NetBurner Community Forum

Bump for information. What are the next steps? Anything I can do to get this thing operational again?

Thanks!

It was plugged into custom hardware, yes. But I think it would be pretty unusual for it to see higher than 3.3V on any pin. We've got a few of these that have been running in the same hardware for quite a while now. But that doesn't eliminate the possibility.

Is there any other checks I should ...

Silkscreen on the module (just below the RJ45) states:
NETBURNER
MODM7AE70
REV 1.4

I've got a MODM7AE70 module that became corrupted, and now even the recovery procedure doesn't seem to revive it.

I've got the module installed in the MOD-DEV-70CR base, powered through the mini USB. I'm following the recommended recovery process from the NB Docs.

During recovery process, with ...