NetBurner Community Forum

Are there any updates about the implementation of VLAN tags?

We have built an ethernet to serial module around the SBL2e chip and it works great! Recently we have been getting reports of failure to link to new Gigabit switches (Extreme and Juniper switches to be exact). The SBL2e defaults to Half Duplex if Autonegotiation fails and then seems to be stuck ther...

Thanks pbreed, that makes sense. I have noticed that it works without the DSCLK line pulled high. Should I pull that up anyway?

Well, I figured it out. There are some lines that the SBL2E firmware requires to run, that they don't mention in any of their documentation. In fact there is no documentation on how to build a board around the SBL2E chip at all. The lines that I had to add are: /RCON (pin 3) to +3V, TEST (pin 38) an...

I have built a board around the SBL2E Chip that is simply an Ethernet to single Serial Port board. I am trying to troubleshoot it and was wondering if there was any documentation to show what the minimum connections are on the controller to get it to boot properly. I basically used the SBL2E board s...