NetBurner Community Forum

That was a little premature, sorry. It worked until I restarted the NetBurner. Then the por stopped accepting input again =\

I figured it out. I put a jumper across U1 CTS and it worked fine.

I am setup to ignore all H/W flow control. Once the port works it works "forever" (until I unplug the board)

So last night I figured out that it works randomly. While probing pins the serial port sometimes starts to respond. I tried a new jumper on the UA1 RX EN header and it's working for now after restarting it. Unplugging the device disables input to the port once again. I'm using a carrier board V1.12....

I am trying to use UART1 as my monitor port but so far I'm only able to receive data on the port. I cannot transmit any data on the port. I have a jumper across the U1 RX Enable header and I have tried putting jumpers on the CTS and RTS headers related to UART1. Is there something else I need to do ...